Alfie
Well-Known Member
Fitted the bare-co PTO cover today. I had to completely remove the yellow corrugated section from the rotovator side due to interference with the clutch bolts & existing cover on the rotovator but that was easy after heating it in some boiling water to soften it.
Also modified some existing brackets last week so that the tractor can't lift the rotovator too high, doing so would damage the PTO cover & also probably break the PTO drive if in gear !
Also modified some existing brackets last week so that the tractor can't lift the rotovator too high, doing so would damage the PTO cover & also probably break the PTO drive if in gear !