tractorted
Well-Known Member
What's up with them? They're almost the only replacement tyre fitted around hereI don't think I'd put bkt under a wheel barrow anymore
What's up with them? They're almost the only replacement tyre fitted around hereI don't think I'd put bkt under a wheel barrow anymore
Absolutely shocking to grip I had to go and rescue a deutz on a tarred road one day it spun out going uphill with new bkts on it.What's up with them? They're almost the only replacement tyre fitted around here
And look at the picture I put in the workshop thread them tyres were put on 2500 hours ago lWhat's up with them? They're almost the only replacement tyre fitted around here
What pressure was in the tyres . Every loo la on YouTube with a tractor stuck has hard tyres . I made up a gadget for rapid inflation of tyres and have air on the tractors .Absolutely shocking to grip I had to go and rescue a deutz on a tarred road one day it spun out going uphill with new bkts on it.
I think it had good years from new and never a problem
Funnily enough I did notice the wear on them .And look at the picture I put in the workshop thread them tyres were put on 2500 hours ago l
I don't know what pressure he had in them but the old ones used be pumped fairly hard anyway.What pressure was in the tyres . Every loo la on YouTube with a tractor stuck has hard tyres . I made up a gadget for rapid inflation of tyres and have air on the tractors .
I do Tillage and sprained at 13 psi for haulage generally up around 28 depending what I am doing.
no more than 24psi in mineI don't know what pressure he had in them but the old ones used be pumped fairly hard anyway.
You. Couldn't run bkts that soft
You guys with a 7400 do me a favour
Sitting in cab engine running
Hold up arrow on right keypad until left screen goes to diagnostics
Press ok(you now see all engine and transmission parameters)
Press right arrow once
You will see eng sup code 3rd or 4th entry down,as you turn the supervisor dial on right console the eng sup will change values
See what values yours says and at what dial position
Mine is 0 value at 8% on dial and 30 at 35%
seems either then that mine is working or both ours are buggered:Thumbp2:Mine shows 30 at 40%
View attachment 65549
View attachment 65550
And 0 at 8%
View attachment 65551 View attachment 65552
For reference at 30% on my dial it shows 18 on the screen.
Now she would be flat if she is standard power
A very uncommon model.
I've only ever seen 1.A very uncommon model.
:Thumbp2:
Anyone fancy a project? Think the price is a bit high considering the problems!
http://www.pvdobson.com/product/used-machinery/massey-ferguson-7480/
Considering the amount of bits it needs throwing at it 12k is probably closer to the mark.
Pughs have one for similar money but not listing faults it likely has
http://www.rvwpugh.co.uk/used-2128-Used-Massey-Ferguson-7480-tractor.html
And this has been on the market at least 12 months
https://www.cornthwaites.co.uk/products/massey-ferguson-7480/