Case CS 94 controls

Tomjim

Well-Known Member
How do you tip a trailer on a CASE CS94 . Also for the front in loader there is a joy stick built in mine, how do you activate the extra ram on the loader ie I put on a bale lifter today how do I get the rams to move in and out
 
Few photos now
 

Attachments

  • 15892313015578993966643159338716.jpg
    15892313015578993966643159338716.jpg
    107.4 KB · Views: 67
  • 15892313237974185398712219661573.jpg
    15892313237974185398712219661573.jpg
    169.7 KB · Views: 65
  • 15892313588767461943789823279992.jpg
    15892313588767461943789823279992.jpg
    158.4 KB · Views: 65
Few photos now
The joystick is for the spools on the back to tip a trailer, is there taps or a diverter valve to switch between loader and rear spools??

Someone has put a rocker type switch in the top of the joystick by looks, press switch then move joystick left/right to work grab, or that's how it should be.
 
You will see in the first picture that I stuck the pipe from the trailer into the back end of the tractor
 
Right, so in your first pic of the back end the left spool (looking from the back) has pipes plumbed into it permanently by looks, is this spool left/right on the joystick? The right spool where you have the trailer pipe does not have them plumbed in, one of the pipes from the loader has been put into the free flow return, this is on the left just above the plastic leak off container. That pipe needs putting in where your trailer pipe is, there's also a spare pipe with possibly a end missing which would need plugging in below your trailer pipe, can't quite see it well enough. Can you do another pic of the back end from a slightly different angle, sort of stood in the middle please??
 
See attached photos. Trailer pipe is not connected
 

Attachments

  • IMG-20200513-WA0002.jpg
    IMG-20200513-WA0002.jpg
    189.2 KB · Views: 45
  • IMG-20200513-WA0001.jpg
    IMG-20200513-WA0001.jpg
    176.5 KB · Views: 47
Try connecting the 2 wires (green & yellow tape) that are hanging loose by the hose connections on the loader brackets. There’s a diverted valve on the cross member, that should take care of the third service.
The loader looks plumbed in permanently into both rear spools. Simplest solution is taps fitted to 2 of the hoses out by the loader bracket where there’s room and these will lock out whatever service they’re working on the loader and free up one of your rear spools
 
Had a Cs94 for a few years didn't have a loader on it though. The joystick to the right of your seat behind the gears should tip the trailer. If not is there a safety valve somewhere turned off that stopping your hydraulics from working? Did you just buy the tractor or have you it a while and if so was it tipping and working the loader beforehand?
 
There is a leaver sticking out of the console with the joystick to lock the movement of the joystick
 
Back
Top