Looking for The power steering and torque converter pump on a JCB 3D
Whitehouse hydraulics in the UK.Looking for The power steering and torque converter pump on a JCB 3D
In my mind I imagine walking into a store and a man walks out with a peak cap and shop coat and smoking a pipe . He calls out a part number and gets no response from the storemen gazing at porn on their screens . Realising that everything has been going downhill since Maggie Thathcher resigned in 1990 he blows smoke leaving everyone coughing goes out the back and comes back with a wooden box packed with straw containing the pump . Stenciled on the box is £125-15s-7d .Did you try Paul or Richie in Pressure Hydraulics? They should be able to match it up but delivery time could be a issue.
Did you get one?Anyone known where i would get a workshop manual for New Holland 8340 in pdf without having to part with any money ?
Eric Warbuton would the man for a 2nd hand one.Looking for The power steering and torque converter pump on a JCB 3D
I know where there are a few dead or dying JCB ,s . I would go new if it was not too ooo expensive.Eric Warbuton would the man for a 2nd hand one.
I did actually 👍Did you get one?
Looking to swap rims/dishes on back of 2 new Holland’s. They have different centres.
if someone deals in them might be able swap. Or is there a handier way of doing it.
Going to need the 2. One on t6155 other 6050.Which one do you need now, the TM or the TSA rim?
The TSA is more common and should be easier to find.
BreakersLooking to swap rims/dishes on back of 2 new Holland’s. They have different centres.
if someone deals in them might be able swap. Or is there a handier way of doing it.
Agrigear in bailieborough do all that kind of work with rims. They wouldnt be the cheapest id say though.Looking to swap rims/dishes on back of 2 new Holland’s. They have different centres.
if someone deals in them might be able swap. Or is there a handier way of doing it.
Would be interested in the rims if your thinking of selling and buying another pairLooking to swap rims/dishes on back of 2 new Holland’s. They have different centres.
if someone deals in them might be able swap. Or is there a handier way of doing it.
I’ve a set of 18.4 R38 Good Years at 5%, with rims, taken off a TS115 if you are interested.Would be interested in the rims if your thinking of selling and buying another pair
Would anyone know of a working Gandy applicator for sale in the North East preferably?
Took the orbital off my dads 2650 and cleaned all the shite out of it,went back and worked a treat,told him to change the filters and he didn’t,2 years later it started doing the same.Is there many lads that can repair orbital units? A lad i was supposed to bring it to this morning cant do it till next week now and i dont want to have to refit it and take it back out sunday
Just very fine tolerance,we just marked it up so everything went back in the same way.Is there much to taking them apart? I was told theres a certain way to put a tool in to keep it all in line
Just cleaned it out,blew air through the oil galleries etc,very similar to a hydraulic motor inside.Did u just clean it out or replace seals while u were at it?