Ploughing tips and tricks

towbar

Well-Known Member
Would that not be very hard on the tractor and plough. It doesn’t seem that gentle of a curve?
 

Masseyrk662

Well-Known Member
if the pubs were open this wouldn’t have happend
 

Attachments

  • 6CCFAE28-4923-43BB-A53B-A04C89D485CF.jpeg
    6CCFAE28-4923-43BB-A53B-A04C89D485CF.jpeg
    472.5 KB · Views: 91
  • 9C6B40D1-84CB-4AA0-8E9C-2FAF6D93109C.jpeg
    9C6B40D1-84CB-4AA0-8E9C-2FAF6D93109C.jpeg
    296.2 KB · Views: 88
  • FB0EDC37-C487-4403-ACC4-6950669561D7.jpeg
    FB0EDC37-C487-4403-ACC4-6950669561D7.jpeg
    262.3 KB · Views: 85
  • 57FC8DCD-A407-42F6-B7E9-9FA47E664CFF.jpeg
    57FC8DCD-A407-42F6-B7E9-9FA47E664CFF.jpeg
    204.9 KB · Views: 85
  • C9A8135F-ECC0-4959-82F3-BB3AC5074086.jpeg
    C9A8135F-ECC0-4959-82F3-BB3AC5074086.jpeg
    416.7 KB · Views: 85
  • 8558F781-8711-441E-BF11-5E168D4AF52A.jpeg
    8558F781-8711-441E-BF11-5E168D4AF52A.jpeg
    475.7 KB · Views: 89

drew

Well-Known Member
Got some of the ground turned over this afternoon, still wet enough, there’s a bit of a spring in the bottom corner just on the headland and I thought all was reasonably ok till I lifted the plough and went to back out, luckily some liberal use of the side brakes and loud pedal brought it round and drove out of it. It’ll be fun trying to dodge round it with the Harrow:confused::crying::no:D61EB700-94A4-4588-AFFC-8047B0D08935.jpeg
 
Last edited:

Masseyrk662

Well-Known Member
Sorry now again for asking plough questions but can the centre stub the bearing for a disc sits on be got on its own or have you to get the full arm
 

gone

Well-Known Member
Sorry now again for asking plough questions but can the centre stub the bearing for a disc sits on be got on its own or have you to get the full arm
No problem get them, Mike Roche does them.
I have a stock of 3 hole disc stub axles and bearing if anyone wants them.
 

Masseyrk662

Well-Known Member
Are you doing a lot more ploughing than usual this year or why all the breakdowns you never saw before?
No more than any other year but it’s all ley and the last time it was ploughed was with horses and a single furrow plough. Don’t know why the plate at the front broke I think it might be from last year the combi wheel used to catch the ground a bit and it could have damaged it. Also there was only one spacer on one side of the ram which might not have helped. The housing for bar and pin was the victim of a huge stone, the disc today was also a victim of a massive stone
 
Last edited:
Top