New Holland error code

[Arthur]

Does anybody know what dash code tE4 on a TM120 means , TIA

 

[Mike]

Bottom page here suggests - Error Code TE4 - Fan speed signal error

Dont know anything about the site though.

http://home.online.no/~la7ija/newholland-feilkoder.pdf

 

[gone]

Viscous fan f**ked??????????

 

[tinman]

Bottom page here suggests - Error Code TE4 - Fan speed signal error

Dont know anything about the site though.

http://home.online.no/~la7ija/newholland-feilkoder.pdf

stupid question but, why have they them codes listed for a mxm and a tm?
same software?.

to boot, i didnt even know they had a sensor on the fan of all places...:001_unsure:

 

[Arthur]

Bottom page here suggests - Error Code TE4 - Fan speed signal error

Dont know anything about the site though.

http://home.online.no/~la7ija/newholland-feilkoder.pdf

It might be that because she seemed to be blowing the fan harder than usual, wasn't taking much notice 'cause there's a sensor related to transmission temp and I was pumping hydraulic oil constantly.

 

[Mike]

stupid question but, why have they them codes listed for a mxm and a tm?
same software?.

to boot, i didnt even know they had a sensor on the fan of all places...:001_unsure:

An mxm is basically a TM in Case colours.

 

[tinman]

An mxm is basically a TM in Case colours.

i never even was in a mxm i dont think.
not many round here.

 

[Mike]

i never even was in a mxm i dont think.
not many round here.

Spot the difference

http://ads-img.cdn.mbdsrv.com/18_18882_2865708_7/case-ih-mxm-120.jpg

 

[Ó hÉidin]

It's probably more likely a short on the 5v reference line.

Trace the loom from the viscous fan around the radiator cowl looking for damage

If it checks out ok, could be the fan unit as above.

 

[Ó hÉidin]

It's probably more likely a short on the 5v reference line.

Trace the loom from the viscous fan around the radiator cowl looking for damage

If it checks out ok, could be the fan unit as above.

 

[tinman]

Spot the difference

http://ads-img.cdn.mbdsrv.com/18_18882_2865708_7/case-ih-mxm-120.jpg

flippin hell.:001_huh:

i never looked at a mxm tbh.

 

[josh]

flippin hell.:001_huh:

i never looked at a mxm tbh.

Ah you have, it was just blue.

 

[James Waterfall]

The wire clip holding the loom to the fan breaks and the loom gets damaged. Have a route around at it

 

[Arthur]

Sorted, simple really, the plug disconnected at the fan but no damage to the loomThanks lads

 

[tinman]

Sorted, simple really, the plug disconnected at the fan but no damage to the loomThanks lads

how lucky is that.