tm rear lift calibration?
- Thread starter Mayo man
- Start date
CoNaMi
Well-Known Member
From memory I think it's
Key off
Unplug the wire from that pot with the little rod.
Key on for a few seconds
Key off and plug the wire back in.
All dials on rhs clockwise
Quadrant (lift slider) in centre
Draft at 10
Disconnect hitch rods.
Start tractor set at 1100 rpm and move the quadrant all the way up leave for a few seconds and you'll hear the system pressurise. Let it all the way down then.
Move the draft to 0 for a couple of seconds and back to 10.
Key off for a minute to store settings and you should be good to go.
Key off
Unplug the wire from that pot with the little rod.
Key on for a few seconds
Key off and plug the wire back in.
All dials on rhs clockwise
Quadrant (lift slider) in centre
Draft at 10
Disconnect hitch rods.
Start tractor set at 1100 rpm and move the quadrant all the way up leave for a few seconds and you'll hear the system pressurise. Let it all the way down then.
Move the draft to 0 for a couple of seconds and back to 10.
Key off for a minute to store settings and you should be good to go.
https://drive.google.com/file/d/0B5BPDFOmfQ1gcDBHX3V5X0pTSEU/view?usp=drivesdk
Tm workshop manual. Pm me your email to access it.
Tm workshop manual. Pm me your email to access it.
Neil O Brien
New Member
Hey mate could I get that file from you please and thanks I need to calibrate 150 lift in the morning. Thanks mate windgapmechanical@gmail.com